Welcome to our resource for MG Car Information.
|
MG MGB Technical - Earl y OD drive shaft
Finally found the correct driveshaft for my 67 that was converted to the D overdrive. The length is correct, but it did not come with the yoke. Are all the yoke's the same? I do have the old shorter drive shaft. BTW. later mk2 shafts will work, but the threaded cap on the yoke only holds on by a thread and eventually pulled off. |
Bruce Cunha |
Even id they are all the same you will have to get it balanced when you have fitted a yoke, and the prop-shaft half of the two yokes are in line. |
Paul Hunt 2010 |
Thanks Paul. Good point. I am putting in new U joints and then will go have it balanced. It's those little things that smooth things out. |
Bruce Cunha |
This thread was discussed between 27/03/2010 and 28/03/2010
MG MGB Technical index
This thread is from the archive. The Live MG MGB Technical BBS is active now.