 
Welcome to our resource for MG Car Information.
MG MGB Technical - SU vent problem!!!!!!!
| I have dual HS4s that are dumping fuel out the vent tube on hard left hands turns.  I just had to leave an autocross event early due to the problem.  Right now I have the factory steel vent line between the carbs with a rubber hose coming off the "T" and run down as a draft tube behind the transmission.  Has anyone else encountered this kind of problem?  The engine starves for fuel coming out of the turn and runs rough/stalls. I might add that this doesn't happen on right hand turns, and it doesn't happen IN the turn - only coming out of it. The fuel tank is 1/2 full, the fuel pump, regulator, lines, etc... are all new and the carbs were rebuilt at University Motors, so I know standard wear and leaks are NOT the issue. Thanks in advance!!!! | 
| Jeff Schlemmer | 
| I just received an email from Joe Curto. He's the man!!! In case anyone is interested, apparently there's a float for the SU that isn't hinged. That should solve the problem! | 
| Jeff Schlemmer | 
| Hi Jeff Could you please elaborate a bit on that 'miracle float' solution ? Thanks in advance, Gerard | 
| G. B. P. | 
| I'm not 100% certain of the float design, as I haven't seen one yet. I assume that it mounts with the three float lid screws and slides on a center pin through the float chamber. This of course is speculation until I actually get one in my hands. | 
| Jeff Schlemmer | 
This thread was discussed between 21/05/2005 and 22/05/2005
MG MGB Technical index
This thread is from the archive. The Live MG MGB Technical BBS is active now.